eCtune

In the update.readme.txt file the last update detailed is: 0.0.2.3 r13 PRI edition I was looking in the forum and the last was r15... i couldnt find info about r16. I just take a look now.

Hi, whats new in r16 version? Could you add the option to maintain the \"show peak values\" on if you closes and open de program?

Since r14 update this works perfectly and my problem in car was the spark plugs, caused because a gas station worker put 95 octane instead of 98 and one spark plug was damaged in a detonation. No problems woth no/nc.

Why do you set the correction trim at 0%? and how could be the best options to get the lowest comsumption? Could i solve the problem installing the stock o2 sensor and maintaining the wideband too? Today i went in the car over 50kms and 2 times had to turn off ignition and on to clear CEL.

I have marked the \"Disable O2 Heater\" and \"Wideband as closeloop input\" because i have only the uego installed as o2 sensor. I show you my settings (Wideband input is in D12 because in red civic have installed in D12 and in grey(Turbo)civic have installed in D10): http://img819.imageshack.us/img...

In this case, i dont want to tune the low cells below 300mbar... only wants to avoid the CEL light on and o2 sensor error. I told that when im running over 100km/h ie, and going over 10% of gas maintaining this speed and left the gas, the engine is retaining and in some cases the CEL turns on and pr...

Yes, i know that when you are tunning must do in openloop to get nice and real values, but the problem exists when i ridding without laptop and no tunning, and must have activated the closeloop to get lower consumption of fuel.

I have checked this options. I cant see any option to disable o2 stock sensor I only see the closeloop + ve corrections (stock)... but i want that the ecu make corrections to get lower consumptions.

I only have installed the Uego wideband sensor to D10 Port and configured in settings with offset correction and Aem selected. Dont have narrowband sensor, only the uego. Where can i disable the narrow stock sensor if is activated? I want the closeloop activated below 750mbar to get a lower consumpt...

Hi, i have a problem when i go over 100km/h and 4000rpm and left the gas, the Cel turns on and get this: http://img40.imageshack.us/img40/3156/img0801nb.jpg How could i solve this problem? This happens some times, not always. I have to turn off ignition and on again to clear cel or Ctrl+u to clear c...

Calvin, now is ready without issues, i just updated and shows updated to r15 and without message. Thanks!

Something strange happened when upadted.. I used force update.bat and shows this message when finished: http://img27.imageshack.us/img27/8110/capture009s.jpg I open the program and show this: http://img541.imageshack.us/img541/9036/capture010.jpg And then when program is opening shows this: http://i...

updating

Calvin, notify us when finish to check if is solved. Could you take a look to my sugerence with \"display peak values\"? I told you in another thread: Could you add the option that when closes the program remember the option in displays \"show peak values\" so when you open again the program this op...

Hi, after update to r15 version, the update notification is still showing but program runs.