Search found 38 matches
- Sun Jun 21, 2009 7:21 pm
- Forum: Software Support
- Topic: ectune windows 7
- Replies: 3
- Views: 2928
- Wed Jun 17, 2009 6:40 pm
- Forum: Software Support
- Topic: ectune windows 7
- Replies: 3
- Views: 2928
ectune windows 7
anybody know a fix for ectune for windows 7 64bit? says netframework error,netframework 3.5 wont install on windows 7 so is this not compatible im assuming?
- Mon Jun 15, 2009 10:17 am
- Forum: Software Support
- Topic: pig rich between shifts, big boost spikes fluctuations
- Replies: 1
- Views: 1790
pig rich between shifts, big boost spikes fluctuations
Hey guys, I have a few questions. I put the gm 3bar map sensor few nights ago. Loaded up a basemap, started fresh and have a pretty decent tune going. 13.9 to 14.7 afrs crusing, low 11's to high 10's in boost. Now when i shift to the next gear, the wideband swings to 10 flat for a fraction of a seco...
- Wed May 20, 2009 5:38 am
- Forum: Software Support
- Topic: 3 bar/evo 560cc mad problems
- Replies: 12
- Views: 7407
- Wed May 13, 2009 3:02 pm
- Forum: Software Support
- Topic: 3 bar/evo 560cc mad problems
- Replies: 12
- Views: 7407
yeah iv done all that calvin and yeah im not a rookie at this,this is new funky weridnes to me iv tuned the car serval times with diffent engine setups since ectune made its debut and iv had same injectors and map sensor on a d seriers and that was a breeze.so why do you guys think it would be follo...
- Wed May 13, 2009 2:50 am
- Forum: Software Support
- Topic: 3 bar/evo 560cc mad problems
- Replies: 12
- Views: 7407
3 bar/evo 560cc mad problems
alright let me break it down, I had the car tuned pretty straight on my 560s and stock map tried to up the sensor to a 3 bar and loaded a new calibration to suppourt it and initaly its so damn lean it wont run at all just on base i tried messing with the injector offset but it screws the map way up ...
- Mon May 11, 2009 8:39 am
- Forum: Software Support
- Topic: 12.9 to 13.5 at light load vacuum, first 4 columns ok???
- Replies: 7
- Views: 4496
12.9 to 13.5 at light load vacuum, first 4 columns ok???
i get about 12.9 to 13.5 afrs at light load high way cruising, I know this is a little rich, but is it ok? Just dumping a little more gas.... right.. i know 14.5 is what i should be shooting for but i figure it would be fine, just gas mileage will suck.
- Wed Apr 29, 2009 10:17 am
- Forum: Software Support
- Topic: creating a basemap 2 liter sleeved gsr evo 560cc injectors
- Replies: 49
- Views: 25883
- Tue Apr 28, 2009 10:13 pm
- Forum: Track Results
- Topic: 13.57 @ 107mph stock B18B LS integra
- Replies: 4
- Views: 6821
- Tue Apr 28, 2009 10:12 pm
- Forum: Track Results
- Topic: 13.57 @ 107mph stock B18B LS integra
- Replies: 4
- Views: 6821
- Tue Apr 28, 2009 5:50 pm
- Forum: Dyno Results
- Topic: B16A T3/T4 6PSI 203WHP 139TRQ
- Replies: 44
- Views: 27105
- Tue Apr 28, 2009 5:27 pm
- Forum: Software Support
- Topic: creating a basemap 2 liter sleeved gsr evo 560cc injectors
- Replies: 49
- Views: 25883
so if injector offset is discontinued in the new rom, i will have to get my car to idle manually by tweaking the map? On boosted setups do you guys check disable ignition correction above 1031mbar? So what about overall fuel trim, will that be the easiet way in order to get the tune to idle upon sta...
- Tue Apr 28, 2009 1:32 pm
- Forum: Software Support
- Topic: aem wideband, truboost, oil press gauge on same ground??
- Replies: 9
- Views: 6326
- Tue Apr 28, 2009 1:30 pm
- Forum: Software Support
- Topic: aem wideband, truboost, oil press gauge on same ground??
- Replies: 9
- Views: 6326
- Tue Apr 28, 2009 1:26 pm
- Forum: Software Support
- Topic: creating a basemap 2 liter sleeved gsr evo 560cc injectors
- Replies: 49
- Views: 25883