eCtune

I did get the r3, but it snowed a bit here so I will be testing tonight at the earliest, if not tomorrow. When should we be expecting the VSS fixed r3?

calvin wrote: u rather listen to a tuner then to the developer?

So if I use the option that disables both should I also disable them separately or should I leave them active in their separate boxes and only disable with the "disable closed loop and ve correction" box?

I will try to test tonight or tom.

I will try the later next time out.

version 2.1 r2 t2

I was driving tonight and when I hit the clutch to idle while turning my tach bounced to zero and then the CEL came on. I had my laptop hooked up and it was giving me a primary o2 code. I dont know why I got this because I have my o2 and heater disabled. I clear the code and the car ran fine. It wou...

Was the log and cal of any help?

Here you go.

PLX m300 connected to D14

So if you select ignition cut in the rev limiter tab this applies to anti-lag, FTL, etc

Here is the log. The first pull is with the lean protection disabled just to make sure that was what was causing it. The second pull was with the lean protect 1 enabled with these settings Min rpm 4507 Min Throttle 30% Above Load 6.08 psi Maximum afr 1.51V 13.02 AFR Max lean duration 270 msec Hope t...

Ill post up a log when Im back home, its on my laptop.

I am using D14 with the PLX m300. Do I need closed loop enabled for lean protect to work?

Im using 2.1 r0 right now. This is what happens, I have my lean protection enabled like this (using lean protect 1) Min rpm 4507 Min Throttle 30% Above Load 6.08 psi Maximum afr 1.51V 13.02 AFR Max lean duration 270 msec Now my car is running about 11.5:1 at in boost and right when I hit 6 psi it cu...

I always use 20-30 added FV and I always do 50deg retard, that way it'll max out the retard at -6 which gives me full boost on 2 step within 1 or 2 pops. Same thing works with fuel cut, only it takes a bit longer to build boost and its much quieter. So say in a setup with the FTL set at 6500, what ...