eCtune

calvin wrote:which port is the hulog?

hulog is port 2

try to run manual connect and post comm trace again. select proper port I tried again same thing is happening except now the cel blinks 3 times. here's what it says This is on manual DTL: baud: 38400 DTL: The operation has timed out. DTL: Retry #:1 DTL: The operation has timed out. DTL: Retry #:2 D...

that sounds good. if cell flashes you are now running ectune. which FTDI driver version do you have? can u install latest. make sure datalogging baud is that 38400 make sure j12 is cut All that's already done. Version 2.2.4.0. Is the baud rate and the bits per second under usb port properties both ...

calvin wrote:uninstall and reinstall ectune

Ok I reinstalled ectune now I can upload a base and cal. to the ostrich but I still can't datalog? It is saying the same thing "Object reference not set to an instance of an object" and the cel flashes twice now when I key on

I checked and its in the ecu right I also tried unplugging the ostrich from the ecu and installed a chip and the car runs fine on the chip with no cel. I am also getting an error when I try to upload a base and cal. to the ostrich It keeps saying Object reference not set to an instance of an object....

The light just comes on and stays on ostrich mounted wrong? Solid cell is a very big reason not to get connected! But the ostrich is connecting fine? would it be connecting if it was installed wrong? I'll check but I'm pretty sure it's in right, the red line goes toward the middle of the ecu right?...

doesn't get data from ecu. is the ecu running ectune? if you Key On what do u see tell me all the blinks of the MIL light The light just comes on and stays on would you be able to remote connect to my laptop? If so what time/When My number is 443-205-2976. I need to get up and running as this is my...

This is debug on manual DTL: baud: 38400 DTL: The operation has timed out. DTL: Retry #:1 DTL: The operation has timed out. DTL: Retry #:2 DTL: The operation has timed out. DTL: Retry #:3 DTL: The operation has timed out. DTL: Retry #:4 DTL: The operation has timed out. DTL: Retry #:5

this is the debug test when its on auto DTL: Auto-Scan DTL: Ecu detection started DTL: baud: 38400 DTL: Cached port failed with Object reference not set to an instance of an object. DTL: Open port : 5 DTL: Open port : 5 DTL: Open port : 6 DTL: Open port : 6 DTL: Open port : 9 DTL: Open port : 9 DTL:...

I can't connect to the hulog. It says can't connect to ecu. I've tried changing the serialcommdebugg to true and downloading the driver from moates. The car also starts but as soon as it starts it cuts off right away. There is also a solid cel. Thanks

now I cant even connect to the ostrich. The emulator tab in ectune is not highlighted, I cant click it. I've tried restarting both ectune and the computer? Nevermind figured it out. The email I got from xenocron told me to save the license file as license.xml but the file downloaded as just license...

now I cant even connect to the ostrich. The emulator tab in ectune is not highlighted, I cant click it. I've tried restarting both ectune and the computer?

I installed the license that i was emailed after I registered the ostrich but It wont turn green the emulator connected in ectune?? Do I have to wait for the ostrich license to be verified too??