eCtune

I designed this harness so that you can use existing connector sensors (even if the plugs are different from OBD2 to OBD1....you can still swap them and plug it into the trans) so that you aren't stringing wires all through the engine bay. The location of the sensors are close enough to be able to r...

Car is complete except the car does not shift properly. Car shifts the same with or without the TCM connected. I have an obd2a to obd1 jumper harness from rywire and their tech support is no help at all. I am on my 2nd auto the first was obd2 and this one is obd1. Could this just be a bad tcm, wiri...

Looks good man. I bet if you short shifted sooner into second, it will help you out a lot. Also, if you keep breaking tranny parts, I would recommend someone to heat treat them. I have gone through tons of tranny gears and finals and finally got some to hold after the treating. Good job though man.

Took some measurements between a BKR7E and a R5671A-8. On the BKRE7, the insulator is projected past the base end of the plug/shell, by approx. .065\". On the R5671A-8, the insulator is recessed approx. .035\" from the base end of the plug/shell. Approx lengths from tip to tip: BKR7E = 2.975\" R5671...