eCtune

gaskleppie contact me please! thank you.

Those are really good number for n/a, especially that much torque! I just need some clarifications if I may. I myself am trying to tune individual cylinders on my jrsc integra type r. I did a good 3rd gear pull, but the timing marks were not clear at all, couldn't notice any type of marks. There we...

to my knowledge its sleeved but i could be wrong not 100% sure.

B18c 84mm Eagle Rods / cp pistons Jg B16 Head Ctr Cams Edelbrock IM 70mm TB PTE 1000cc Dual Walbro's pump gas 92 GM3bar PWM eCtune boost solenoid Mini Ram manifold GT3582R 3\" Down pipe / Full exhaust Tial 38mm / open DT 16.2 psi creeping a little. Its on winpep 6 so it looks a little jagged.

B20/vtec Eagle Rods / Arias pistons. 84mm ported b16 head. Ctr Cams Ported JG edelbrock victor x 70mm TB Equal length Ram horn. Precision sc6162e 3\" open DP Tial 38mm Dump tube under the pan. 32x12x3 Intercooler 2.5\" Charge pipe GM 3Bar 680cc injectors single walbro fuel pump. pump 92 octane 13.8 ...

simple setup eagle rods / je pistons Stock B16 head _ Ctr cams Stock ITR IM 680cc injectors :cry: He's going to get a bosch 044 inline and rewire his current walbro. And a Set of PTE 1000's AEM 3.5 bar map sensor Pump 92 octane Full Race equal length. Precision sc60 .60 cold side .63 hotside 3\" Dp ...

on your fuel rail were the feed line adapts through the banjo fitting check and see if theres a straight through hole in the fitting . i have this issue alot on AEM rails and what i do is drill a hole in the fitting. and it gets rid of it. i had a guys z6 on the dyno and no matter what i did it went...

she wasnt breathing like i would have wanted. i wasc using the closedloop ebc feature it helped. but it was using a stock TB>IM. Down pipe could have been bigger and i was fighting with heat soak. thats why there was 50 something runs. other than that this car was fun. 1gen crx car was sick. Timmy y...

I do both.. I start off with the standard retard, then once fueling is good I'll add 2 deg at a time globally to the WOT/Boosted area, then compare graphs to see where TQ is increasing and where its not, then if theres any areas where there wern't good gains I'll pull back timing in those areas.. T...

OK so, I pulled up my last used cal on my b16t... from my old injectors. Adjusted the dead time per the sheet T1 sent with my injectors. car wont idle and is dumping a shit load of fuel. What pre set inj batt offset should I be in to begin with? No wideband hooked up yet because I dont want to foul...

haha, I was gonna post that it sounded like the map sensor was pegged out, but somone else posted for him to check before i did lol.. i've seen that happen many times with the GM 3 Bar, the little connectors come loose, or the customer wires it in wrong and it reads full boost all the time. No CEL ...

Bugermass wrote:I'll pitch in on a wiki.

x2

map sensor ground

do you have a wireless connection?(internet)