eCtune

We use two Endyn Catch Cans also right now. The one from the block drains back to the block. The one from the head needs to be checked from time to time. We have not had much oil build up in them. I will be trying a Check valve setup to the exhaust to help evacuate or create a vacuum in the block ca...

Calvin, Lowering the first collum value to 85 has worked for me also. The latest version cought the error even after I lowered it to 90 85 seems to be working good. Thanks .

Good write up. I will use this and try out the closed loop boost control. Thanks.

Download for .NET Framework 3.5 I installed it and R4 last night. All is well so far. I will do sometesting this weekend and fill out and Excel sheet. http://www.microsoft.com/downloads/deta ... laylang=en

oh oki. i see u have a S2 Throttle body. that could also be a cause of the bad idle. almost all of the S2 TB i have dealt with give very bad idle unless u increase the stop screw adjustment you are saying Basically setting the throttle plate partialy open? I do have the air screw out almost all the...

\"Boosted K20\" Thanks, But no I am not on B20vtec. Dave, Thanks for the help on the phone. Moving the IAT to the charge pipe helped alot with the idle. I also Cut the Alt C wire and helped with the idle.

Yea the car has Omni power full drag setup. and a full race traction bar. It goes straight as an arrow also. I would like to get the 60' a little better We will try to lower the boost on launch. We are still testing different setups with the chassis. We may raise the rear a little also. Thanks

I will update the Tune and Log in the tuner section.

SPFWD Integra Wayne's / Randy's Turbo Full Race Pro AM kit. 42R Turbo Top mount Divided ex. Block 84mm GSR Block O-Ring Inline Pro Sleaved / Build 9.8:1 Pistons Eagle Rods Head GSR Custom Ported Head Type R Cams (Int. adv2deg Ex Ret.2deg) Springs, Retainers Ti. Full Race Intake Manifold 1600cc RC in...

I noticed the same problem Dave has stated. I have an autometer gauge with the sensor located in the head. right next to the ECT sensor. The autometer gauge is higher the the ECU readings.

1.79 1.80 60' time 112 114 MPH 11.70 11.90 1/4 Mile time

The Cams we original had were from RLZ. I think they were made by WEB cams. They broke after this race. We switched to Skunk 2 Pro 3 cams. Scat 95mm crank 86.5mm bore and Portflow head. 116 VP fuel this put down 262HP. The engine was originaly built by inline pro. We had some bad rod bearing wear an...

Very Nice! What cams are you running?

sounds like fun. Is this a 1/8th mile track? and what is your 60' times? just courious

Nice Setup. What boost controller are you using? GM sol with eCtune or a standalone controller?