eCtune

this is from a few days ago 9400rpms has been helping me out, he gave me a new one to upload with a smoothed map, havent played with it yet.

two major problems im having is the tune is varying so much from day to day with different weather, and i havent been able to get the ECT and IAT corrections right, and i have large peaks and drops in the fuel map that i cannot seem to smooth out without going rich or lean in some spots, some areas ...

i am quite aware that it is only for reference, however it is important from what i understand when using the tuner auto adjust feature, which i have been using

Just wanted to get some suggestions on what my AFR target tables should look like...heres how i have it setup now, couple people i talked to said they dont like the clarity of the table on the vac side because it jumps too much between columns and isnt progressive enough, but i havent found a way to...

actually all motor helped me out alot last night and today and i did actually get a new basemap setup and was able to drive the car around, i recorded a datalog file around the neighborhood to get some numbers in the vacuum areas of the map before i start pushing into boost and im trying to edit the...

I have been having nothing but issues trying to get ectune to run properly on my car. It is a 95 acura integra (automatic) with a P75 ecu with a demon installed. I have a set of 420cc bosch design 2 injectors that I bought off honda tech that i have no information on other then the size. I was origi...

gotta use the automatic ecu so that it has the hardware for it

well i had chris from xenocron write me a basemap chip, and i chipped the ecu just fine, apparently he wrote it on crome. Im able to use all of my gears fine, 1-4, and shift between overdrive and regular drive, however i just threw a tranny code for the torque converter lockup solenoid not engaging....

did alot of reading today and the 74hc373 provision you were talking about i assume is the blank spot inside the ECU for mounting a removable Eeprom. In which case.... im looking at this kit here.. http://www.xenocron.com/chipping-kit-w-sst-chip-obd1-ecus-p-277.html which im assuming is calvin's rom...

and you say calvins rom, what is that?

See this is all new to me, the emanage was just plug and play, i know a bit about the eproms and chips etc from my profession but do i need to have the ECU chipped before I used the moates demon that comes with ECtune? Or is it good to go already because of the fact that its an OBD1 P75 already. Wha...

also, the car does have a separate trans control unit on the drivers side floor, harness plugs going into the main ECU are... shift position control switch automatic lockup solenoid

Before i dump this emanage ultimate for ectune, I need to know if ectune will work on a 95 integra with an automatic transmission and a P75 obd1 ECU without killing the ability to use the automatic. Im extremely pissed off i spent almost 700 dollars for this emanage ultimate + extra harnesses, and t...