eCtune

http://www.youtube.com/watch?v=bZaO-ezeUZw 10.55 run

Here is a pic from early this year the only differerance now is the coil

10.55sec in the 1/4 142mph 2nd run lowered the boost in first and turned off closed loop boost control. (For now) I need to work on the boost control

SPFWD 94 Integra Wayne's / Randy's Turbo Full Race Pro AM kit. 42R (.97) Turbo Top mount Divided ex. Full Race Back door intercooler 2.5� Intercooler Piping Custom 4� full exhaust Block 84mm GSR Block O-Ring Inline Pro Sleeved 9.8:1 Pistons Eagle Rods Head GSR Custom Ported Head Type R Cams Spri...

I just tested also with no problem. Turned on launch control and did not change any settings. drove over MPH and it worked fine. .60 ROM

Were you at E-town?

Nice build. What Car is this in and what trans?

MikeySpec wrote:Is/was this Loofosky's old engine?

Yes

Yes the wiring is definatly suspect on this car.

I just had the same problem. Trying to tune with Ostrig 2.0 car would cut out. I sometimes seen the VSS drop to 0 on the log. then I burned a chip for the car and it does not cut out. I will try a distributor tommorow also.

We are unsure. I haven't taken the motor apart yet. We bought this engine fully built. I generally clay the engine I built that have setups like this but the customer was told everything was good with the motor. It will be apart this week. A new build is allready in proccess.

I accually did lower it to 4800rpm on friday. It did make the power come in earlier. no real change to the overall. On another note the engine droped a valve on saterday at BOTI Maryland. We will be rebuilding hopefully the block is ok. Piston in #4 is a bad and the head took a big hit. Rev limit wa...

Engine- 90mm H23 block. Sleeved by RS machines Billet 102mm Crank Custom Cunningham Rods 15:1 CR JE pistons H22 head ported by Portflow Ferrea Valves Custom Grind Crower cams Crower springs/retainers 52mm TWM ITBs portmatched to head 550cc injectors Ericks Racing Header Kaizen Speed Balance Shaft Re...

Nice Numbers! I have the same anti Lag issues with our 42R. Very slow We have to start antilag when we light the first light then stage the second light.

I did an 01 Accord with an F23. It did not have an adjustable Distributor either. I just changed my base maps until I got the timing set. Basically I only hade to offset the tables by 3 or 4 degrees to set my base.