600 HP Integra
Moderator: Gaskleppie
- integralactic
- Posts: 43
- http://phpbb3styles.net
- Joined: Tue Apr 03, 2007 6:55 pm
- Location: Kamuela, Hawaii
600 HP Integra
Finally got my car to the dyno. 83mm AEBS sleeves Arias pistons Pauter rods Portflow head REV valvetrain ITR cams GT35R turbo Bosch 044 fuel pump Rockett race fuel 613hp and 431ft./lb. torque @ 28lbs boost thanks Ectune!!
- xenocron
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 1012
- Joined: Wed Apr 04, 2007 7:00 pm
- Location: New Jersey
- Contact:
In a 4 door none the less...nice!
Regards, Xenocron Tuning Solutions eCtune Team eCtune Authorized Tuner Location: Ringwood, NJ / Hillburn, NY U.S.A. www.xenocron.com DIY ECU Chipping, Fuel Management Parts and more...
- yc underground
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 114
- Joined: Mon Apr 09, 2007 4:29 pm
- Location: York, PA
- Contact:
Nice good numbers
Regards, eCtune Team eCtune Authorized Tuner Location: York, PA, USA www.ycunderground.com www.facebook.com/YCUDynoTuning
- Boosted K20
- Posts: 100
- Joined: Tue Apr 10, 2007 10:33 pm
- Location: New York
- integralactic
- Posts: 43
- Joined: Tue Apr 03, 2007 6:55 pm
- Location: Kamuela, Hawaii
thanks for the kind words everyone. I actually have the eCtune boost controller but it was not hooked up when I went to the dyno. Right now boost is controlled by a Blitz EBC but will be replaced by the eCtune EBC when I get a chance to go to the track and do some test runs. When I went to dyno the car I totally forgot to change the spring in the wastegate to a stiffer one, so the boost wasint staying steady at high RPM on higher boost levels. when I get to the track Ill put a stiffer spring and test out the eCtune solenoid.Boosted K20 wrote:did u use eCtune boost controller?