Page 1 of 1
600 HP B16A2
Posted: Sat Jun 14, 2008 8:07 am
by ge0ne
It was time to post it, a few months ago, i tuned a turbo EK B16. Car made 602hp at 8670rpm and 52.3kg of torque at 8182. Only that we couldn't measure it till the rev limiter cause it continually spin on the rollers after 8600... Rev limit is at 9600. Car runs on 2 bar with an 60-1 and is fully built. 84mm CP pistons Pauter rods Darton sleeves Crower cams Full Ferrea valvetrain Port and polish Ram horn Manifold 3'' exhaust Turbosmart external 1000cc injectors Prodrive 280lt/h pump Aebs I/M Precision I/C MSD 6AL Ignition Big thumbs up also go to Xenocron, for making lot of this parts come in Greece in time
Posted: Sat Jun 14, 2008 10:28 am
by xenocron
Nice job George! Track times?
Posted: Sat Jun 14, 2008 12:49 pm
by ge0ne
I know you would be interested, car will hit the track at september. But not much expected due to its weight (car is a 4 door). Either way after some secret test results car did a 12 sec pass with 220km/h exit on the 1/4 mile
Posted: Sun Jun 15, 2008 12:14 am
by sewell94
Nice
Posted: Sun Jun 15, 2008 1:22 pm
by yc underground
x2
Posted: Fri Jul 11, 2008 1:07 pm
by ge0ne
And a video from the car on the dyno... Remember car spinned after 8500 rpm it had 1000 more to go. Tuned on 2 bar (29 PSI)... Video is dedicated to Chris AKA Xenocron. Video here -->
http://youtube.com/watch?v=PaEHBR-b3rE Sound is bad when Vtec kicks in...
Posted: Fri Jul 11, 2008 3:56 pm
by xenocron
Sick stuff Georgey poo
