Page 1 of 1
B20/vtec 440whp 278trq 13.8 psi
Posted: Fri Jun 19, 2009 2:11 pm
by FACETUNED
B20/vtec Eagle Rods / Arias pistons. 84mm ported b16 head. Ctr Cams Ported JG edelbrock victor x 70mm TB Equal length Ram horn. Precision sc6162e 3\" open DP Tial 38mm Dump tube under the pan. 32x12x3 Intercooler 2.5\" Charge pipe GM 3Bar 680cc injectors single walbro fuel pump. pump 92 octane 13.8 psi
Posted: Sat Jun 20, 2009 1:10 pm
by b20beast
sweet is this on stock sleeves?
Posted: Sat Jun 20, 2009 10:05 pm
by FACETUNED
to my knowledge its sleeved but i could be wrong not 100% sure.
Posted: Wed Jun 24, 2009 5:31 am
by MeRtCaN
good
Posted: Thu Sep 10, 2009 8:48 am
by VTEC Inside
I know it's old thread but ... I'm building B20B block with B16 head for turbo and will be installed in '92 Civic hatchback converted to AWD and I was wondering how much is safe with stock sleeves? I will install block guard and/or block posting as well. Or should I resleeve the block. I'm talking for 400-500hp. Thanks! -Mitko