Thanks Calvin! Stock Turbo GSR numbers
Moderator: Gaskleppie
- xenocron
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 1012
- http://phpbb3styles.net
- Joined: Wed Apr 04, 2007 7:00 pm
- Location: New Jersey
- Contact:
Thanks Calvin! Stock Turbo GSR numbers
This isnt anything special, but I thought I would make a point to post this today since when I started up eCtune this morning I almost freaked when it had locked me out! But I called up Calvin and within 15 minutes basically he had me up and running again! This was a very simple setup that made great power...usually I find that if I add 20-30% to these dyno numbers (yes 20-30%) I come out with more accurate figures. I had a 286 whp sleeved motor @ 13 psi last week run an 11.2 @ 125mph if that gives you any indication on how low this thing reads. But it tunes nicely and I barely have to change anything once the car gets back on the street. Posted the final Calibration as well...enjoy!
- Attachments
-
- Shane-final-StockGSR-PT525cc-StockMap-EbayKit-T3T4.cal
- Shane Dyno - Stock GSR - PT525cc High Injectors - Ebay T3/T4 Turbo Kit - Stock Map Sensor 6-7psi
- (8.08 KiB) Downloaded 227 times
Regards, Xenocron Tuning Solutions eCtune Team eCtune Authorized Tuner Location: Ringwood, NJ / Hillburn, NY U.S.A. www.xenocron.com DIY ECU Chipping, Fuel Management Parts and more...
- calvin
- <font color=gray>Site Admin</font><br><font color=green>eCtune Authorized Tuner</font>
- Posts: 4816
- Joined: Tue Apr 03, 2007 10:16 am
- Location: Paramaribo, Suriname
- Contact:
Nice numbers, keep up the good work. Finally somebody posting a calibration.. I'll download it and repost it in tuners/calibration tomorrow
Regards, eCtune Team eCtune Authorized Tuner Location: Caribbean & Suriname aim:calvinPGMFI skype:ectune We remote connect to your laptop if you have problems. Best support in the world.
- xenocron
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 1012
- Joined: Wed Apr 04, 2007 7:00 pm
- Location: New Jersey
- Contact:
hopefully it lasts longer than three weeksDmc1 wrote:Wow that cdm t3/t4 is flowing some cfm for that much power at only 7psi.
Regards, Xenocron Tuning Solutions eCtune Team eCtune Authorized Tuner Location: Ringwood, NJ / Hillburn, NY U.S.A. www.xenocron.com DIY ECU Chipping, Fuel Management Parts and more...
- yc underground
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 114
- Joined: Mon Apr 09, 2007 4:29 pm
- Location: York, PA
- Contact:
Nice number, mustang dyno are low reading dyno compare to most dyno. Add 20% should get you near a dynojet reading. Sometime you have to recalibrate the dyno to that car to get a more accurate reading. But good work I bet it's fast.
Regards, eCtune Team eCtune Authorized Tuner Location: York, PA, USA www.ycunderground.com www.facebook.com/YCUDynoTuning