Page 1 of 1
Air Compressor Clutch signal (A15): not working
Posted: Wed Sep 24, 2008 12:03 am
by CRXDrew
I have been troubleshooting my nonoperating AC compressor clutch. Basically I have come down to the conclusion that the signal from the ECU (pin a15) is non-responsive. (I applied ground straight to the harness which operated the clutch) I have AC enabled and I'm not using the A15 an an output. hmm.... any thoughts?
Posted: Wed Sep 24, 2008 1:17 am
by calvin
no clue it should work out of the box.. what about ac cut?
Posted: Wed Sep 24, 2008 9:01 am
by CRXDrew
AC cut is not activated. Once I find a minute I'm going to troubleshoot it more... might have a defective ecu. I think i'll see if I can make the pin activate as an GPO. *shrug*
Posted: Wed Sep 24, 2008 11:17 am
by calvin
good thinking
Posted: Sat Sep 27, 2008 10:17 pm
by HiProfile
My car doesn't activate the clutch, but I was under the assumption it wouldn't activate if coolant pressure was too low. I've already got the ac pin to activate as a GPO, only thing I could guess is a bad ecu or bad clutch in your case.