Page 1 of 1
TB - No EVAP \"Nipple\"
Posted: Mon May 31, 2010 12:58 pm
by civic4g
Hi My TB has EVAP \"nipple\" and hose connected to canister, if I buy a new TB without EVAP nipple it's OK to have the hose venting to atmosphere or because the the associated danger should I find an alternative way no connect it? Where please. Thanks in advance.
Posted: Mon May 31, 2010 5:02 pm
by Vtec6000
There won't be any issues with leaving the pipe off but if your very concerned then you could plumb it in to the air intake pipe.
Posted: Mon May 31, 2010 7:31 pm
by JaredKaragen
Leave it disconnected; it won't hurt much but the environment when the pcs is active. Most obd2 models flowed the evap in a different manner than obd1.
Posted: Tue Jun 01, 2010 4:32 am
by civic4g
My first concern wasn't the environment, I was concerned with the flammability of the gases, is that not an issue?
Posted: Tue Jun 01, 2010 9:23 am
by Vtec6000
Highly unlikely
Posted: Tue Jun 01, 2010 2:44 pm
by TopMountGSR
We delete those carbon canisters on every setup that leaves here..