Page 1 of 1
Tool for Knock detection
Posted: Wed Apr 09, 2008 7:24 am
by David974
Posted: Wed Apr 09, 2008 8:33 am
by Almighty-Si
YIKES!!! That thing is like $400. I mean its nice and all but it costs a ton more than reading plugs or making det cans. $400 also buys a ton of dyno time.I mean if you street tune your fuel, 4 hours on the dyno should be enough time to tune your timing. I mean sure its a lot cheaper than replacing a motor and it would be nice to have that little bit of extra protection daily but at that price I think going with dyno tuning would be a better idea.
Posted: Wed Apr 09, 2008 9:04 am
by David974
i'm agree with you but in some place worldwide dyno time isn't cheap like in USA just a question where the best place to put the Det Cans? on B18C regards
Posted: Mon Apr 14, 2008 12:59 am
by boostedeh2
Posted: Mon Apr 14, 2008 8:16 am
by Almighty-Si
Oh sorry. I forgot about this thread. I didn't click the link but I am sure its in there but just bolt the end of it to a bolt on the front side of the block.
Posted: Mon Apr 14, 2008 9:03 am
by David974
Posted: Sat Dec 01, 2012 4:51 pm
by antoni
have someone try this one out?