fuel cut settings

Richie2 · Post by **Richie2** » Thu Jun 26, 2008 10:20 am

Im getting fuel cut hickups during crusing at around 1k-3k rpm and light throttle. I changed the fuel cut settings to tps below 1% and mbar below 119 and fuel cut still cuts at below 198mbar and 6% tps randomly mainly during lifting throttle a little e.g. from 7% to 4%, causing lean conditions. Any suggestion on how to make it cut only at high vacum , or is this tip-in related?

Post by **calvin** » Thu Jun 26, 2008 10:39 am

increase your TPS to 10%... and test...

greasemonkee · Post by **greasemonkee** » Thu Jun 26, 2008 10:57 am

Some time ago, (couple releases) open/closed loop would behave differently on the same fuel cut settings. Not sure if it was addressed since then

Post by **calvin** » Thu Jun 26, 2008 11:07 am

greasemonkee wrote:Some time ago, (couple releases) open/closed loop would behave differently on the same fuel cut settings. Not sure if it was addressed since then

i'm not aware of that... and i don't think this related. and explain if you will

Richie2 · Post by **Richie2** » Thu Jun 26, 2008 11:37 am

calvin wrote:increase your TPS to 10%... and test...

would that be in the fuel cut tab in (below tps) or in the fuel trims tab?? If its on the fuel trims, tps tip-in is allready in 10%.

Post by **calvin** » Thu Jun 26, 2008 12:12 pm

fuel cut tab.. in fuel trim you adjust the amount of fueldump during tip in