GPO and FTL input help (fixed)

Richie · Post by **Richie** » Fri Jul 25, 2008 9:12 am

Ok, first issue I have is with the launch control input. Im using the service check as input to enable it, it works fine, but Is there a way I can get rid of the solid MIL light when using SCC input????? I thought it was disable once the car was runing. The other issue is with the secondary maps and GPO. using enable second maps with GPO and Ac request B5 input, IT DOES NOT CHANGE to secondary maps. If I go to secondary maps and set it with input B5 and uncheck the enable with GPO, IT DOES WORK. With the GPO option it doesnÂ´t work at all. thanks in advance.

Post by **calvin** » Fri Jul 25, 2008 6:33 pm

Put your SCC input to none.. under features.

Post by **calvin** » Fri Jul 25, 2008 6:34 pm

with GPO it works.. make a log file and post the test calibration

Richie · Post by **Richie** » Sun Jul 27, 2008 2:54 pm

It all works perfect now. The only thing is that i had to change the GPO min tps to -10%, because it wouldnÂ´t work on 0% while on idle. Thanks again.