error codes

fireztorm · Post by **fireztorm** » Wed Sep 17, 2008 3:05 pm

i just tryed ectune now and i get these error codes: Electrical Load Detector defective circuit or unplugged / defective sensor. And BARO Sensor (Atmospheric Pressure) defective circuit or unplugged / defective sensor. what could be wrong?

Post by **calvin** » Wed Sep 17, 2008 4:14 pm

you just have to disable those sensors. Probably your ecu doesn't have them.

fireztorm · Post by **fireztorm** » Wed Sep 17, 2008 6:18 pm

ok i shall try that. but when i drive my car there is a rev limiter at 3500rpm why? and i can not change the settings in the boost table setup.

Post by **calvin** » Wed Sep 17, 2008 6:49 pm

3500rpm it looks like SOLID cell not sure.. post cal and a log

fireztorm · Post by **fireztorm** » Fri Sep 19, 2008 4:04 pm

it works now. i disabled the sensors. but i cannot set the settings in boost table. if i go into boost table and set the \"add 120% fuel per psi\" and \" retard timing 0,75\" settings on and then press apply nothing happens, and if i go into the boost table again then nothing happens to the settings.

Post by **calvin** » Fri Sep 19, 2008 6:52 pm

how many columns do you see on your screen?

fireztorm · Post by **fireztorm** » Sat Sep 20, 2008 10:47 pm

i see 8

Post by **calvin** » Mon Sep 22, 2008 12:14 am

8 columns is not possible count again