FTS/limiter question - confusion

greasemonkee · Post by **greasemonkee** » Fri May 01, 2009 8:14 pm

I've never messed with the FTS until now. I find it strange that if the rpm during a shift is over the resume rpm, it still blips a little fuel and consequently rpm do not seem to drop as one would expect.

Post by **calvin** » Thu Jun 04, 2009 8:41 am

I just tested on the bench FTS set to 4000 rpm Tps to 50%. if tps< 50 % and rpm >4000 it cuts to 4000 rpm and restores the cut if rpm <4000 if it goes above 4000 rpm it cust again. see log.

Post by **calvin** » Fri Jun 12, 2009 8:05 am

can this be tested with the 0.0.2.2r3 that will be released now?

greasemonkee · Post by **greasemonkee** » Fri Jun 12, 2009 2:43 pm

The last .cal I made was with ver 0.0.2.2r8 . I'll have to retune for current version? If not I can test.

Post by **calvin** » Fri Jun 12, 2009 3:23 pm

greasemonkee wrote:The last .cal I made was with ver 0.0.2.2r8 . I'll have to retune for current version? If not I can test.

no retune required. send me your cal by mail