I Was tuning my Low Cam, Part Throttle. So i decided to Enable the LEAN Protection Feature, and Re Enable VTEC at 3000 RPM, so i could Tune the Vtec Map. When the motor accelerates to 3000rpm it would not rev past that rpm. Moved the VTEC point at 4000rpm. Also have the same issue. Also disabled the LEAN Protection, and I have the same issue. Is there anything i should i check? ALSO to be noted I had another TUNED Map, Switched over to it, and Everything seems fine. Boost Fine, Vtec is fine.
if it seems aunchecked you can try changing the offset of the wideband sensr under settings... For example write down 2 or more value if you are not having a target AFR maps also.. than it won't be able to get lean value from the sensor...
utkuselamoglu wrote:if it seems aunchecked you can try changing the offset of the wideband sensr under settings... For example write down 2 or more value if you are not having a target AFR maps also.. than it won't be able to get lean value from the sensor...
ah i get ya, one more problem.... In the 'cells' there are like 2 colums and about 4 rows, they dont datalog they have "-" in them do you understand what i am trying to say.......? UPDATE "The Cells were LOCKED"
b20beast wrote: i think i cleared them select like 4 cells right click -->tuner ---> and click lock selection... you will understand
Okey While data logging you can lock wanted cells You should be able to unlock them also:) If you can not change those setting than your cal file may be corrupted...
b20beast wrote: i think i cleared them select like 4 cells right click -->tuner ---> and click lock selection... you will understand
Okey While data logging you can lock wanted cells You should be able to unlock them also:) If you can not change those setting than your cal file may be corrupted...
sorry for the confusion... those were 2 separate issues.....