RoadXY wrote:Guess you are Peter then? If so, excuse my enthusiasm then Have looked through all your posts but could make up if you where.
Yes its me I always try to follow the forums/topics about my apps. So, the eCtune DEMO is done, but i need to test it before i'll upload it to the android market.
RoadXY wrote:Guess you are Peter then? If so, excuse my enthusiasm then Have looked through all your posts but could make up if you where.
Yes its me I always try to follow the forums/topics about my apps. So, the eCtune DEMO is done, but i need to test it before i'll upload it to the android market.
Ive been going nuts... I have my HULog out and repinned a cable to use on the bluetooth adapter. I am using a +5V signal from my Arduino. I switch the adapter to AT, and plugged it all in, and shared grounds between Arduino and HULog. No matter what it just wont take any AT commands... If I plug both into power they connect to each other... so I know they work... but for the life of me they wont take AT commands so I can connect with a 3rd party device... Have you had any trouble like this? You think the HULog is locked into a specific UART speed keeping me from having a 38400 TTL connection to the adapter?
95 Sol Si : D16z6 : TD04H-13C 74 Civic 1200 : 100% Stock
Have looked through all your posts but could make up if you where.
I always try to follow the forums/topics about my apps. So, the eCtune DEMO is done, but i need to test it before i'll upload it to the android market.
[/url]