Page 1 of 1
fuel cut settings
Posted: Thu Jun 26, 2008 10:20 am
by Richie2
Im getting fuel cut hickups during crusing at around 1k-3k rpm and light throttle. I changed the fuel cut settings to tps below 1% and mbar below 119 and fuel cut still cuts at below 198mbar and 6% tps randomly mainly during lifting throttle a little e.g. from 7% to 4%, causing lean conditions. Any suggestion on how to make it cut only at high vacum , or is this tip-in related?
Posted: Thu Jun 26, 2008 10:39 am
by calvin
increase your TPS to 10%... and test...
Posted: Thu Jun 26, 2008 10:57 am
by greasemonkee
Some time ago, (couple releases) open/closed loop would behave differently on the same fuel cut settings. Not sure if it was addressed since then
Posted: Thu Jun 26, 2008 11:07 am
by calvin
greasemonkee wrote:Some time ago, (couple releases) open/closed loop would behave differently on the same fuel cut settings. Not sure if it was addressed since then
i'm not aware of that... and i don't think this related. and explain if you will
Posted: Thu Jun 26, 2008 11:37 am
by Richie2
calvin wrote:increase your TPS to 10%... and test...
would that be in the fuel cut tab in (below tps) or in the fuel trims tab?? If its on the fuel trims, tps tip-in is allready in 10%.
Posted: Thu Jun 26, 2008 12:12 pm
by calvin
fuel cut tab.. in fuel trim you adjust the amount of fueldump during tip in