eCtune

Posted: **Fri Jul 25, 2008 7:06 pm**

My Gauge is reading low but the data column reads 235F and doesnt move from 235F....car is not running hot

Posted: **Sat Jul 26, 2008 4:13 am**

replace ECT sensor, and or check wiring from ECT sensor to ECU. The guage in the cluster reads from a different single wire sensor.

Posted: **Sat Jul 26, 2008 5:20 am**

sometimes if there is an air pocket it will read incorrect.. but it sounds like your ECT is buggin out on ya.

Posted: **Sat Jul 26, 2008 11:59 am**

why is the gauge reading correctly but program is reading something different

Posted: **Sat Jul 26, 2008 4:08 pm**

Bugermass wrote:replace ECT sensor, and or check wiring from ECT sensor to ECU. The guage in the cluster reads from a different single wire sensor.

^^^

Posted: **Sat Jul 26, 2008 4:54 pm**

so the ECT sensor sends direct to ECU?...either way...doesnt the dash have to get a single from that sensor right wether it be from some other signal wire...

Posted: **Sat Jul 26, 2008 6:36 pm**

Dude.... you really need to read the posts above once again

There are 2 sensors. The cluster has one sensor. And the ECU uses its own sensor. Different sensors. Different wires all the way. /Allan

Posted: **Sat Jul 26, 2008 9:08 pm**

so change sensor on the motor cause thats the one that is not working properly

Posted: **Sun Jul 27, 2008 7:08 am**

There are 2 on the motor...

Posted: **Sun Jul 27, 2008 11:41 am**

ohhh okY

Posted: **Sun Jul 27, 2008 6:42 pm**

eCtune

ECT Problem

ECT Problem