eCtune

In the fuel map I'm using the realtime trace. I'm wondering if any weight is given updating values when I hit ctrl + and ctrl -. It appears to increment or decrement all 4 values equally. I strongly dislike this type of update as I like to move only one cell at a time. Can we have a feature to disable the 4 cell selection and just select the best one? -Michael

When smart tracking is enabled? I'll make the following options...

• single cell 4 cells(equal) From current cell to last column 1 row from current cell to last row 1 column from current cell to last row and last column

How about this as well? Suppose the 4 selected cells are A,B,C,D. Have an option that weights your change so if you're 90% closer to cell A and the remaining proximity is only 10% for the others then the change is weighted as such. This is how we did the auto-learn on the VEMS stuff and it did have some success. It would also be cool to have buttons or quick keys to enable/disable the different trace options. When I'm tuning I will tune with vtec turned off. Then I enable it at 4000 and tune the vtec map finally picking a crossover point when I'm finished. So when I'm doing the vtec I like to have it switch with vtec on so I can see the timing and fuel jumps in real-time but when the pull is finished I like to disable the trace so it stays in the vtec map so I can make my changes. Sound complicated enough? Buttons and quick keys YAY for them. -Michael

really i can do the weight thing with no problem.. But not now.

If you select single cell tracking would you like to see single trace on your tables tooo?

Did you see that demo I emailed to you? I'd like to see single cell plus little lines or spots showing where in the cell you're at. -Michael

found it

That would be nice but the current grid component i can't draw...

fixed, single with weigh