Page 1 of 1
Innovate serial stream not working
Posted: Fri Jan 30, 2009 4:41 am
by integralactic
I updated to r7 I try to connect datalog with Innovate serial wideband input enabled, datalog connects but O2 reading display stays at 10afr. Close ectune and opened up logworks. It connects and displays the AFR. Tried disabling then enabling, tried switching ports, rebooting laptop but it still dosent work. Is anybody else having this problem? Any ideas? It was working before I updated.
Posted: Fri Jan 30, 2009 6:37 am
by butch11a
same here...
Posted: Fri Jan 30, 2009 8:59 am
by calvin
i was afraid of that.. i'll look at today test it. i added some code i'll release an update today
Posted: Fri Jan 30, 2009 9:08 am
by calvin
did you select innovate and the correct port in settings?
Posted: Fri Jan 30, 2009 4:50 pm
by integralactic
Yes selected innovate and chose correct port, com8.
Posted: Fri Jan 30, 2009 5:38 pm
by calvin
I'll test in a few hours and release an update. Sorry. But on the otherhand more wb users will have direct serial access.
Posted: Sat Jan 31, 2009 1:19 am
by calvin
please force update from start menu and test again. post asap. i just tested it
Posted: Sat Jan 31, 2009 4:30 am
by integralactic
Just tried it and it is working now.
Posted: Sat Jan 31, 2009 7:04 am
by ef92b
great! i'm going to do the update later tonight. I was having the same issue just last night(30th) as what integralactic described initially.
Posted: Sat Jan 31, 2009 9:23 am
by Gaskleppie
serial is working! confirmed this morning.
Posted: Sun Feb 01, 2009 5:57 am
by ef92b
works perfectly fine now.
done 25 min. continuous datalogging and it's all good. thanks calvin!
