eCtune

I have a problem, when datalogin, the map sensor reads 5.0 volts on idle, and no change at all, and tps shows 0%, no matter if I'm pressing the gas pedal, and voltage stays with no changes at 0.47. car is smoking black, please help me asap guys,

Did you calibrate TPS?

ls_dx wrote:Did you calibrate TPS?

I do

you might have the tps and map sensor connectors mixed up.

non-vtec wrote:you might have the tps and map sensor connectors mixed up.

No Sir, not mixed up cpnnectors. This starts since ectune crashed when I was adjusting my car. And now the map I was using has 11.24 psi in all the columns, no vacuum columns at all. Wierd

No idea what happened, but you can try to upload an older file.

try upload+baserom and ectune crash would likely not cause the tps/map not to read on KOEO

calvin wrote:try upload+baserom and ectune crash would likely not cause the tps/map not to read on KOEO

I´ll try. But map/tps are not reading also with the engine on

they should first read with key on engine off. map sensor should be arround 1024mbar. tps 0% and moving if you play with throttle.

If you can use a Volt Meter to check voltages from map and tps to verify its not mechanical/electrical

problem fiex, tps was broken on the inside. change for another tps, did the calibration and done. Thanks guys

good!