eCtune

hi, I've just started exploring ectune and since I can't find a definitive guid on how to initially setup the injectors, can anyone confirm if this is the correct way to do it: after creating the basemap, i load the injector calibration menu, fill in the fields, and adjust the 'injector offset' until I get a decent A/F reading (@ idle/warm). Then in the parameters menu, adjust the battery offset, to get a steady A/F under different voltage conditions. (leaving the 14,16v field, as that was the starting point to wich i initially calibrated the injectos to, right?). Much appriciated.

thats pretty much it

Yes, and you can test this table by disconnecting the alternator and see what the af does when the voltage drops.

Thanks for the replies. Still confused though The injector offset adjustment (in the calibration menu) adjusts the injector offset in 'FV'. But what is the difference in adjusting the battery offset in 'ms' for the 14,16v row. Isn't the endresult the same?

not exactly.. The injector offset works always, and the battery offset only works at a certain voltage point. See it as a dead time compensation for bigger (slower) injectors.