Page 1 of 1
vacuume colums on table reading backwards
Posted: Tue Nov 10, 2009 2:34 pm
by jpjackson
i am new to ectune so go easy, when i was watching my data i noticed that it said my vac was only 12hhmg at idle and knew that couldn't be, and then i looked at my vac gauge and im at 22hhmg, and i noticed that the columns at the top that show what vac that column should be is reading backwards IE column 1 is 3hhmg and then column 8 is at 23hhmg. is this a bug or do i have something set wrong? thanks for the help
Posted: Wed Nov 11, 2009 9:21 am
by non-vtec
post a screen shot. you might have the map scalers set wrong...if you go into the settings you can change it.
how????
Posted: Wed Nov 11, 2009 10:29 am
by jpjackson
how do i go about placing a screen shot? im new with this so i appreciate the help
Posted: Wed Nov 11, 2009 7:36 pm
by non-vtec
press print screen on your keyboard. paste in ms paint and save as jpg. then upload it to this post.
RE
Posted: Thu Nov 12, 2009 8:40 am
by jpjackson
ok cool, thats good to know, but i think i got it. i had it reading in mmhg, not inhg, my bad. but thanx for the help. off subject maby you can look at my othere post about the data logging problem and give me some ideas. thanx