eCtune

http://forum.ectune.com/viewtopic.php?t ... g&start=15 could some one who has an lc-1 check out this post and give me a hand????? i just got a new lc-1 and running serial but it is not working in ectune

ok nevermind, i got it working. update firmware on lc-1,(well not update, reload i.e. clean install), have everything closed and turned off, plug in your ostrich, and hulog, and serial to usb wideband,turn key to on position, open and start ectune, click connect datalog and emulator, start car, and working. those are the steps i had to take to get it working right. so just if anyone else has this same problem, here is the steps.