ebc current and ebc target still read in Mbar in graphs????
Posted: Sun Feb 21, 2010 1:56 am
i have my units set to inhg for vacuum columns, and i have my boost columns set to PSI, now when i play back a log file and use the graphs, ebc current, and ebc target are still shown in M bar while boost reads PSI and MAP read vacuum/PSI. yet when i play back the file and watch my data bar, target boost is still shown in PSI, why is this? can i change it somewhere? it just throws me off a bit, it would be easier if it read in psi, at least for me. can this option be added to change the units of measurement in the graphs?
