EBC Still swapping to NO after program close

ckretvix · Post by **ckretvix** » Sun May 23, 2010 11:08 am

The bug that switches the boost control option NC/NO after close is still there. As in I select NC, and the program swaps it back to NO after saving and closing the program and reopening.

Maddog20 · Post by **Maddog20** » Sun May 23, 2010 11:28 am

Man, that is wierd because I have had no issues. Have you tried to make a new cal from scratch? Maybe its a hardware problem are you using Demon or Ostrich? Verify that all you com port settings are correct. Maybe good idea to use wipe the FTDI Drivers and reload and start from scratch.

Vtec6000 · Post by **Vtec6000** » Sun May 23, 2010 11:30 am

I assume you hit return on keyboard after change before you close the parameters window?

yc underground · Post by **yc underground** » Sun May 23, 2010 1:56 pm

bug still there

patrick_yi_82 · Post by **patrick_yi_82** » Sun May 23, 2010 5:24 pm

yup.. same problem here

Post by **calvin** » Thu May 27, 2010 10:06 am

can somebody point me out the exact steps i tried to replicate it. but i was not succesful to reproduce this bug..

sIrK · Post by **sIrK** » Thu May 27, 2010 3:46 pm

I checked this... 1.-Open the ectune 2.-create a new calibration 3.-set the boost to Normally open 4.-Save the file as temp.cal 5.-Close the program 6.-Open the program 7.-Open last calibration 8.-Check the option, and is in Normally close. All the files that you open are in normally close. only is in NO when you create a new one.

patrick_yi_82 · Post by **patrick_yi_82** » Thu May 27, 2010 9:10 pm

It happens to me, when I open my previously saved CAL

b20beast · Post by **b20beast** » Mon May 31, 2010 12:16 pm

same here. when i close, and last rom re opens, it set back to NO

bigdaddyvtec · Post by **bigdaddyvtec** » Tue Jun 01, 2010 3:44 am

b20beast wrote:same here. when i close, and last rom re opens, it set back to NO

yup i couldnt figure out why my cars boost controll is all over the place. Happening to me too.

sIrK · Post by **sIrK** » Sun Jun 06, 2010 7:19 am

The problem persists after update

Post by **calvin** » Thu Jun 10, 2010 9:09 am

solving it now!

sIrK · Post by **sIrK** » Thu Jun 10, 2010 9:22 am

Calvin, after update to r14 i have a new problem and i think that is with EBC... could you take a look to this thread? -> http://forum.ectune.com/viewtopic.php?p=24778#24778 Thank you

Post by **calvin** » Thu Jun 10, 2010 9:22 am

fixed uploading test version for pro only can somebody test?

sIrK · Post by **sIrK** » Thu Jun 10, 2010 9:25 am

I will do now. Im doing the update...