eCtune

The bug that switches the boost control option NC/NO after close is still there. As in I select NC, and the program swaps it back to NO after saving and closing the program and reopening.

Man, that is wierd because I have had no issues. Have you tried to make a new cal from scratch? Maybe its a hardware problem are you using Demon or Ostrich? Verify that all you com port settings are correct. Maybe good idea to use wipe the FTDI Drivers and reload and start from scratch.

I assume you hit return on keyboard after change before you close the parameters window?

bug still there

yup.. same problem here

can somebody point me out the exact steps i tried to replicate it. but i was not succesful to reproduce this bug..

I checked this... 1.-Open the ectune 2.-create a new calibration 3.-set the boost to Normally open 4.-Save the file as temp.cal 5.-Close the program 6.-Open the program 7.-Open last calibration 8.-Check the option, and is in Normally close. All the files that you open are in normally close. only is in NO when you create a new one.

It happens to me, when I open my previously saved CAL

same here. when i close, and last rom re opens, it set back to NO

b20beast wrote:same here. when i close, and last rom re opens, it set back to NO

yup i couldnt figure out why my cars boost controll is all over the place. Happening to me too.

The problem persists after update

solving it now!

Calvin, after update to r14 i have a new problem and i think that is with EBC... could you take a look to this thread? -> http://forum.ectune.com/viewtopic.php?p=24778#24778 Thank you

fixed uploading test version for pro only can somebody test?

I will do now. Im doing the update...