Page 1 of 3
After R14 Still having problems with EBC
Posted: Tue Jun 08, 2010 4:19 am
by sIrK
I cant explain in english, i show you a video... This happens after update the ectune, i dont know if is a bug with ebc or is casuality with a problem of my engine. I leave the video. The boost cut is over 1.55Bar ebc control is over gear 1.4max in 5th and 4th gear. I push the gas in 3rd and when gets 1.2bar begins to trrrr trrrt rrrr and some explosions, i cant uderstand what happen, only think that could be something with ebc control. help please.
http://www.youtube.com/watch?v=-TQj4w0aSDo
Posted: Tue Jun 08, 2010 4:03 pm
by 9400RPMS
whats the gap on your plugs... sounds like your having some combustion issues..??
Posted: Tue Jun 08, 2010 4:06 pm
by sIrK
Yes, is the first thing that i supposed. But no, because this was after update the ectune, and sounds like solenoid when is working... and only does when gets 1.2bar. below this car works perfectly.
Posted: Thu Jun 10, 2010 9:23 am
by sIrK
In second 5 is when the turbo does the trrr trrrr... at 1.2bar
Posted: Thu Jun 10, 2010 9:23 am
by calvin
just check your solenoid operation and duty cycle. u need to know if your solenoid is connect NO or NC
Posted: Thu Jun 10, 2010 9:28 am
by sIrK
My solenoid was working well in NO. But after update to r14 have this problem....
Posted: Thu Jun 10, 2010 10:00 am
by calvin
there was bug where NO switch to NC. i just updated ectune
Posted: Thu Jun 10, 2010 10:27 am
by sIrK
Calvin, do you know if could be a problem with EBC? this trrrrrrrr at 1.2 began to do after upgrade to r14... and i know that was a bug that now is solved with NO and NC option. My solenoid is from xenocron, a pwm and was working in Normally open option, always activate avobe 1027mbar and controlling the turbo in gear based.
Posted: Thu Jun 10, 2010 10:28 am
by calvin
NO is now solved in r14.2 release today
Posted: Thu Jun 10, 2010 10:49 am
by sIrK
I will try to test it at this night.
Posted: Fri Jun 11, 2010 6:33 am
by sIrK
I couldnt test the new version last night because was raining and the car dont grip well... today is raingin again, i will leave news when i test it in the car. The option when open the program and check the solenoid configuration now is ok. I hope that works fine now...
Posted: Fri Jun 11, 2010 7:57 am
by calvin
ok
Posted: Sat Jun 12, 2010 3:32 pm
by sIrK
I test the car this afternoon with new release r14.2 but when the car gets 1.2bar begins to going bad... explosions and trrrtrrr... Below 1.2bar runs perfectly.
Posted: Sat Jun 12, 2010 11:58 pm
by DSMR
Datalog? Sounds like you are blowing spark out. How cold are the plugs and what gap do you have them at?
Posted: Sun Jun 13, 2010 1:28 am
by 9400RPMS
i said this early, its a gapping problem..damnt... thats what it sounds like.. its something with the plugs i doubt its ectune.