smart tracking bug
Posted: Fri Jun 08, 2007 4:10 pm
I haven't had much time to play with the latest R7 yet but here is a tiny bug I noticed. If you have the graph view focused and hit Alt-T it will lose focus and the graph view will regain it again. Perhaps we can just have a display with the graph or the table and not both. I normally use the graph view to tune so I can see the fuel curves. Another small one I was sure I had reported earlier... If you use the \"G\" key to jump to a cell then the arrow keys to move the selection (while in graph mode) the next selected cell is relative to the last selected not the one that was selected upon hitting \"G\". Often during a pull I will hit \"G\" to move to a lean spot then visually will see that the problem lies in a cell adjacent so I like to use the arrow keys to move to the problem cell and adjust it... -Michael