Boost Cut and EBC Problem

rich777 · Post by **rich777** » Tue Jan 18, 2011 5:53 pm

Hey guys Can someone take a look at my map and datalogs please and tell me where i'm going wrong. I keep hitting boost cut for some strange reason. Also my EBC seems to be work backwards and i'm positive i've got it setup properly (100% DC = WG pressure 0%DC = Full boost) . Is the way i have the ebc setup in the pictures below correct ? Thank you all for your time Richard

4thgenhtch · Post by **4thgenhtch** » Wed Jan 19, 2011 2:44 am

Hey I`m richard too

Yes your vacuum is setup right, I was having the same issues theirs a glitch in the program, switch NO to NC or vice versa in the software... and go from there map out your duty cycles, for your look up tables and then you can fill out your boost by gear tables from that... http://forum.ectune.com/viewtopic.php?t=2871

rich777 · Post by **rich777** » Wed Jan 19, 2011 4:59 am

Ha Ha,

Hows it going ? Thanks for that i'll give it a go at the weekend. What about the boost cut problem ? Can anyone explain why i'm hitting boost cut ? Thank you

rich777 · Post by **rich777** » Thu Jan 20, 2011 2:23 pm

Anyone ?

rich777 · Post by **rich777** » Wed Jan 26, 2011 12:23 pm

Is where i'me getting the power supply from ok ? Its coming form the distributor. Thank you

4thgenhtch · Post by **4thgenhtch** » Sat Feb 12, 2011 7:57 pm

Yea from the dizzy is fine, Whats your cut set to? So you cant get the boost to regulate? Take the line off the wg and blow into it and make sure its venting from the filter on the side...

rich777 · Post by **rich777** » Wed Feb 23, 2011 4:49 am

Sorry for that late reply. I have sorted this now. I just started a new map and i don't seem to have a problem now. Strange......

92redhatch · Post by **92redhatch** » Thu Mar 03, 2011 1:09 pm

Set your ebc to normally closed. And start at 0 psi

rich777 · Post by **rich777** » Sun Mar 06, 2011 2:06 pm

Thank you, i'v sorted it though...