eCtune

Hey all. Been a while since I last posted. I have a small issue which I'm assuming is a bug in the software. I use a tunerview 2 so to datalog I need to be set to 921600. If I set the datalogging port speed to that number hit save and then connect, everything works. But once I disconnect or close eCtune the port speed defaults back to 38400. Basically what it boils down to is, every time I connect to datalog I need to go into settings and set the port speed. Initially it was tolerable but now it's becoming a little frustrating. I looked around and didn't see anyone else mention the same issue. Any ideas?

If you put the TunerView into daisy mode via the settings menu you can use 38400. Remember to set it back to normal before connecting via the TunerView software.