Page 2 of 2
Posted: Thu Feb 16, 2012 5:35 am
by skc4g
RoadXY wrote:Guess you are Peter then? If so, excuse my enthusiasm then
Have looked through all your posts but could make up if you where.
Yes its me
I always try to follow the forums/topics about my apps. So, the eCtune DEMO is done, but i need to test it before i'll upload it to the android market.
Posted: Thu Feb 16, 2012 5:37 am
by RoadXY
skc4g wrote:RoadXY wrote:Guess you are Peter then? If so, excuse my enthusiasm then
Have looked through all your posts but could make up if you where.
Yes its me
I always try to follow the forums/topics about my apps. So, the eCtune DEMO is done, but i need to test it before i'll upload it to the android market.
Great support! Will be awaiting the update.
Posted: Sun Feb 19, 2012 4:32 am
by skc4g
RoadXY wrote: Great support! Will be awaiting the update.
Datalog with eCtune support is on the
market
Posted: Sun Feb 19, 2012 4:46 am
by RoadXY
Great!
Posted: Wed Mar 14, 2012 4:01 pm
by JaredKaragen
Ive been going nuts... I have my HULog out and repinned a cable to use on the bluetooth adapter. I am using a +5V signal from my Arduino. I switch the adapter to AT, and plugged it all in, and shared grounds between Arduino and HULog. No matter what it just wont take any AT commands... If I plug both into power they connect to each other... so I know they work... but for the life of me they wont take AT commands so I can connect with a 3rd party device... Have you had any trouble like this? You think the HULog is locked into a specific UART speed keeping me from having a 38400 TTL connection to the adapter?
Posted: Thu Mar 15, 2012 2:12 am
by joppez
I have 2 different bluetooth. Elechouse and some other. Elechouse i managed to work but not other one. You can also order bolt on part here:
http://www.elechouse.com/elechouse/inde ... ts_id=2164
Posted: Wed Jan 01, 2014 5:12 am
by skc4g
Posted: Wed Jan 01, 2014 5:13 am
by skc4g
[/url]