Ostrich to Demon
Moderator: Gaskleppie
-
- Posts: 4
- http://phpbb3styles.net
- Joined: Sun Aug 08, 2010 4:04 am
- Location: Slidell L.A.
Ostrich to Demon
Im having problems connecting to the ecu with the newer software. I had heard others were having problems as well and switched. Is there a way I convert my license from Ostrich Pro to Demon pro?
- Gaskleppie
- <font color=gray>Site Admin</font><br><font color=green>eCtune Authorized Tuner</font>
- Posts: 1263
- Joined: Tue Apr 03, 2007 11:22 am
- Location: Netherlands
- Contact:
- JaredKaragen
- Posts: 1504
- Joined: Fri Nov 23, 2007 4:00 am
- Location: Bay Area, Ca
- Contact:
Inu experiences I have found the demon to be more unreliable in connection issues than the ostrich; in fact the ostrich is extremely solid and reliable. Every demon customer of mine that gets tunes on ectune (or any applicable ems); I tune them on my license/ostrich, then upload that .cal to their emulator in the end... no worries about disconnects and what not, and no breach of licensing. I have all my hardware inside the PCM case with 2 USB cables and the LM2 analog out cable hanging out of the case. Each of those has a ferrite bead on the end, same with all other USB/power cables in my tuning gear. Ostrich connection issues are few causes that I have come across: Emi: hid's, ignition mods(nology wires, msd, etc), etc Bad grounds Faulty/old cables
95 Sol Si : D16z6 : TD04H-13C 74 Civic 1200 : 100% Stock
- cain_tuned
- Posts: 65
- Joined: Fri Aug 20, 2010 8:44 pm
- Location: puyallup wa
- yc underground
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 114
- Joined: Mon Apr 09, 2007 4:29 pm
- Location: York, PA
- Contact:
I'm starting to think it's just the demon board & firmware itself. Notice lot of connection & freezing issue with multiple demon setups, and not just with eCtune setup.
Regards, eCtune Team eCtune Authorized Tuner Location: York, PA, USA www.ycunderground.com www.facebook.com/YCUDynoTuning