eCtune

In the fuel table, When I select \"Est. Fuel Change\" from Overlay selector and datalog some, the cells that I hit are highlighted with data and other cells are blank. When I then click on \"Clear map trails\" the chart doesn't reset or clear. I think it should. Am I wrong on this?

There's a button that says \"clear all logging info\" or somesuch that will clear the overlays. Clear map trails is just to clear any map tracings that have occured if you have it enabled.

thank you borrat. You have clear all recordings CTRL+C Map trails.. You can trail when making a run where your trace have been. If you use that with rpm vs AFR you can see where you have to adjust