Page 1 of 2
High Cam Only Map Selection Does Not work
Posted: Mon Dec 17, 2007 1:18 pm
by xenocron
I am trying to do a Single Cam Non VTEC that is revving higher than 8000 so I wanted to use the VTEC Maps only so I have table cells above 8000 rpms. If I selected the HIGH CAM MAP ONLY under Fuel & Ignition Table settings, it is still using the Low Cam Fuel and Ignition maps...
Posted: Mon Dec 17, 2007 2:29 pm
by calvin
fixed and send it to your email. When i was debugging Alt VTS output i left it in
Posted: Mon Dec 17, 2007 6:25 pm
by xenocron
Thanks...
Posted: Mon Dec 17, 2007 8:48 pm
by calvin
worked bro?
Posted: Tue Dec 18, 2007 9:13 am
by xenocron
Unfortunately I had to tune the car on the low cam maps only...I was in the middle of the tune when I posted the bug and didnt see your email until after I was done tuning
Posted: Tue Dec 18, 2007 9:15 am
by calvin
fuck... let me see if i can do it in bench test mode
Posted: Tue Dec 18, 2007 9:20 am
by calvin
i cannot see in bench mode... I'll have to test in the car. Can somebody else maybe test.. Just a running car.. Select high cam only and then see if it switch to VTC maps
Posted: Tue Dec 18, 2007 9:22 am
by xenocron
I will try today in a car I have here at the shop...
Posted: Tue Dec 18, 2007 9:36 am
by calvin
47 it was working tooo.. 48 in included atl vts output. whre i left some stuff during debugging.
Posted: Wed Dec 19, 2007 11:45 am
by calvin
Xenocron please report back asap
Posted: Wed Dec 19, 2007 6:52 pm
by xenocron
My car died...I spent the whole time today trying to fix it
Posted: Thu Dec 20, 2007 6:49 pm
by Civic Tsi
I used it on a car last summer on rom 45. Seems to work well.
Posted: Thu Dec 20, 2007 6:58 pm
by calvin
yeah there was a little bug in 48
Posted: Wed Dec 26, 2007 1:27 pm
by calvin
i need feedback onthis
Posted: Thu Dec 27, 2007 11:20 am
by xenocron
Confirmed working with Calvin last night.