Page 2 of 2
Posted: Fri May 23, 2008 9:49 pm
by calvin
i just release a test update. Send me a mail i'll give u beta version tooo
Posted: Wed Jun 11, 2008 2:25 am
by JaredKaragen
yes in current (not new expiry release) I am seeing the bug where you can't lower or change the col1 mbar value; goes back to previous setting... not low enough to avoid the error. (new tune)
Posted: Wed Jun 11, 2008 8:18 am
by calvin
r9 correct? That is fixed in r11 being released today. r11 will only popup onces this msg. It will also ask to lower the mBar of column 1.
Posted: Wed Jun 11, 2008 9:15 pm
by JaredKaragen
Correct r9. Thanks!
Posted: Fri Jun 13, 2008 10:48 pm
by b20vtechb
so this will be fixed in the update tommorow? i too noticed the colum changing to b1 and not being edited in mbar like it should be.
Posted: Fri Jan 23, 2009 12:00 am
by 2kCivicSi
Question.. in my non-boosted B16, the last column is set to 1024. With the cold temps and high baro, I am reading a WOT map pressure of about 1050... and ECTune only hilights two cells in the last column instead of 4 cells.. Could this cause a similar problem to what you guys are talking about with the lower bounds?
Posted: Fri Jan 23, 2009 3:07 am
by Gaskleppie
Go to the fuel table parameters and change the number of columns to 11. I have seen this also with a good working ram air! This way you get the first boost column on screen. Thats were your other 2 cells are reading.
Posted: Fri Jan 23, 2009 10:35 am
by calvin
Gaskleppie wrote:Go to the fuel table parameters and change the number of columns to 11. I have seen this also with a good working ram air! This way you get the first boost column on screen. Thats were your other 2 cells are reading.
thanks