Page 1 of 1
possible bug??
Posted: Mon Apr 14, 2008 10:26 pm
by non-vtec
hey Calvin. it may be related to my cal. file but it never seen this before with the previous version of ectune. it happened twice since the new update a couple days ago. it happened once. i rebooted the whole laptop and it happened again. both times it happened with the datalog ecu connected. not logging any data just connected and i was just cruising around watching the display data's. is there something i need to change in my cal. or is it a possible bug?
Posted: Mon Apr 14, 2008 10:52 pm
by z31
I believe that's the new warning Calvin installed to warn you to set your mbar lower in your first column. I use 80mbar and I've never seen this. This was on decel correct?
Posted: Tue Apr 15, 2008 12:41 am
by relic1
Posted: Tue Apr 15, 2008 12:46 am
by calvin
eCt look nice in vista. Lower column 1 is not a bug. Your load(mbar) is lower then column1 and that can cause problems during decel fuelcut
Posted: Tue Apr 15, 2008 6:34 am
by non-vtec
ok will change that. p.s. that is not vista....win xp pro
Posted: Tue Apr 15, 2008 7:23 am
by calvin
ok... Test it...