Page 1 of 2
Datalogger won't connect to ecu/Fixed/Hulog cable wrong
Posted: Wed Apr 30, 2008 9:18 pm
by OneRM
Ok, so i just got everything setup. Did my ectune update, did my ostrich update, updated my usb ports. Everything is working and I've loaded a basemap however the datalogger won't connect. popup says can't connect to ecu.
Posted: Wed Apr 30, 2008 9:42 pm
by calvin
make sure j12 is cut. Check in device manager which port your datalogging uses.(don't plug in your ostrich). Now that you have the right comm port open settings->datalogging Disable auto-scan Select correct comm port Baud 38400 And press test
Posted: Wed Apr 30, 2008 11:43 pm
by boostedeh2
my datalog won't connect unless the key position to \"ON\"...Don't know if that would help.
Posted: Wed Apr 30, 2008 11:47 pm
by zex_cool
that is how it works. key on; datalog on...key off; datalog off.
Posted: Thu May 01, 2008 12:35 am
by calvin
ecu is off if key is off
Re: Datalogger won't connect to ecu
Posted: Thu May 01, 2008 12:54 am
by boostedeh2
OneRM wrote:Ok, so i just got everything setup. Did my ectune update, did my ostrich update, updated my usb ports. Everything is working and I've loaded a basemap however the datalogger won't connect. popup says can't connect to ecu.
yup, did you turn your key on when you were trying to connect?
Re: Datalogger won't connect to ecu
Posted: Thu May 01, 2008 12:56 am
by boostedeh2
OneRM wrote:Ok, so i just got everything setup. Did my ectune update, did my ostrich update, updated my usb ports. Everything is working and I've loaded a basemap however the datalogger won't connect. popup says can't connect to ecu.
yup, did you turn your key on when you were trying to connect?
Posted: Thu May 01, 2008 9:06 am
by OneRM
tried with key on and car running, both no go. I'll check j12 to make sure its cut, that may be the problem. I'll keep you posted.
Posted: Thu May 01, 2008 9:32 am
by calvin
hard set the comm port and the baud should be 38400
Posted: Thu May 01, 2008 9:39 am
by OneRM
cut j12 and changed to com port 5, with 38xxxx baud setting. Still no change.
Posted: Thu May 01, 2008 10:10 am
by calvin
if you key on how many flashes do you see?
Posted: Thu May 01, 2008 11:25 am
by OneRM
how many flashes? where would it be flashing. I don't see any flashes on CEL or in software.... Thanks for the speedy responses btw.
Posted: Thu May 01, 2008 12:46 pm
by Almighty-Si
If you have uploaded a basemap when you put the key in the on position your CEL will light then go out, this is where you need to pay attention, the CEL will flash again shortly after the CEL goes out.
Posted: Thu May 01, 2008 2:39 pm
by calvin
Pay close attention what u see and hear if u key on. And let me know. Did you do upload base+calibration?
Posted: Thu May 01, 2008 6:02 pm
by OneRM
just did basemap+calibration. still no dice. I do however see 3 flashes if that helps?