update problem

Almighty-Si · Post by **Almighty-Si** » Fri Jul 18, 2008 8:14 pm

Yea, well I don't know what's doing it...getting frustrating. Changed column 1 to 70mbar and that fixed the overflow error, trace still jumps to the last column and it locks up without giving me an error message. So i'm stuck.

james25 · Post by **james25** » Fri Jul 18, 2008 9:24 pm

I think you and me have similar problem bud. So I'll just be watching this thread and hopefully I can find a solution. I know the clicking noise is the main relay. When it clicks, datalogging locks up and stops. Here's a log file when it happened. Main relay clicked and datalogging locked and it stopped logging. Had to disconnect. The last part of the log, notice ECT and IAT 291.00*F MIL on and other sensors reading 0V but the car runs just fine.

EricW · Post by **EricW** » Fri Jul 18, 2008 10:18 pm

james25 wrote:I think you and me have similar problem bud. So I'll just be watching this thread and hopefully I can find a solution. I know the clicking noise is the main relay. When it clicks, datalogging locks up and stops. Here's a log file when it happened. Main relay clicked and datalogging locked and it stopped logging. Had to disconnect. The last part of the log, notice ECT and IAT 291.00*F MIL on and other sensors reading 0V but the car runs just fine.

I've had the same problem two or three times. I disconnected every thing and restarted ectune and the car and it worked fine after that. I've also had a problem when doing multiple data logs and telling it not to save and when i click no it would bring up another program that was opened on the start bar. If i clicked yes and saved it then then there was no problem.

Almighty-Si · Post by **Almighty-Si** » Sat Jul 19, 2008 4:15 am

Well got an overflow message again being set at 70mbar even tried my original .cal so i'm stumped...don't know what else I can do. Guess I will just sit tight and wait for the next update.