will not connect to ecu
Moderator: Gaskleppie
-
- Posts: 29
- http://phpbb3styles.net
- Joined: Sat Jul 26, 2008 3:31 pm
- Location: Norway
will not connect to ecu
i have ostrich 2.0 and hulog extreme with updated firmware and newest ectune pro i can connect to the ostrich and upload map but it wont communicate to the ecu i do not see the mil light flash 3 times and my datalogging does not work at all. ideas?
- calvin
- <font color=gray>Site Admin</font><br><font color=green>eCtune Authorized Tuner</font>
- Posts: 4816
- Joined: Tue Apr 03, 2007 10:16 am
- Location: Paramaribo, Suriname
- Contact:
then there is a problem between ostrich and ecu. what color is the connect when you are connected to emulator? did you put the ostrich cable properly in the ecu?
Regards, eCtune Team eCtune Authorized Tuner Location: Caribbean & Suriname aim:calvinPGMFI skype:ectune We remote connect to your laptop if you have problems. Best support in the world.
- Garrett
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 322
- Joined: Wed Apr 04, 2007 10:09 pm
- Location: Quebec, Canada
when uploading the first time upload base rom & cal and verify it
eCtune Team eCtune Authorized Tuner Location: Riviere-du-Loup, Quebec, Canada www.precisionautocanada.com
real time update is enabled. it verifies correctly, the emualtor works fine, i can load a map into the emulator and download it to the laptop later. but the mil light should give 3 flashes when i have loaded a basemap & calibration to the emulator right? in this case it do not flash, just the regular flash when i hear the fuel pump.
- Garrett
- <font color=green>eCtune Authorized Tuner</font>
- Posts: 322
- Joined: Wed Apr 04, 2007 10:09 pm
- Location: Quebec, Canada
are you sure that de jumper J1 in the ecu is ON? is you remove the ostrich, the car start?
eCtune Team eCtune Authorized Tuner Location: Riviere-du-Loup, Quebec, Canada www.precisionautocanada.com