Problem with setting row values

JaredKaragen · Post by **JaredKaragen** » Fri Aug 22, 2008 4:40 am

NEw .cal, choose default settings, USDM P28 ECU, Maps from a P08. on the last row, try to increase RPM value to 1100, or 1000, or anything above 8.000.... it defaults back to 8.000... I was trying to set up the secondary tables (no VTEC) to activate at 5,000 RPM's so I can have better resolution in my maps above 5,500 RPM's.... but I brick-wall at 8,000... want to step it to 10,000. Thanks!

Post by **calvin** » Fri Aug 22, 2008 9:30 am

low cam can only go to 8000 due to the formula honda uses.

JaredKaragen · Post by **JaredKaragen** » Sat Aug 23, 2008 8:21 pm

ok, looks like I will need to start leaving VTEC on but have sensor error disabled right?

Post by **calvin** » Sat Aug 23, 2008 9:52 pm

checkbox high cam only.. for non vtec high reving..

JaredKaragen · Post by **JaredKaragen** » Sun Aug 24, 2008 9:31 pm

cool. Thanks Calvin.