locking onto current cell

poodlemuffer · Post by **poodlemuffer** » Sun Dec 21, 2008 5:13 pm

there might be a feature but i may not have found it yet. im tuning on load dyno and increasing load and moving across each cell one at a time until there all tuned.only problem was i would have to watch the tracer and move across with the arrows then adjust , is there away of locking onto the cell so i can simply use the ctrl+up/down and it will adjust the cell im on ? thanks.

Post by **calvin** » Sun Dec 21, 2008 6:14 pm

yup tables->tuner->smart track

poodlemuffer · Post by **poodlemuffer** » Sun Dec 21, 2008 8:42 pm

thanks will give that a shot.