Anyone have the Omnipower 3 bar map sensor settings?

Hybrid96EK · Post by **Hybrid96EK** » Mon Mar 02, 2009 6:35 am

Just like the title states. Got an Omni 3 bar map sensor here and I noticed its not in the list of maps in eCtune. I tried messing with the xenocron 3 bar, but that one isn't working. Car doesn't even idle. Let me know if someone here has the settings needed to get this map working. Thanks alot!

Post by **Gaskleppie** » Mon Mar 02, 2009 9:16 pm

Its a motorola sensor so you can use that setting.

Hybrid96EK · Post by **Hybrid96EK** » Mon Mar 02, 2009 11:22 pm

Gaskleppie wrote:Its a motorola sensor so you can use that setting.

I see a Motorolla 2.5 bar, but nothing for a 3 bar. Will the values still be the same? If so, I can just set it up as custom and use the 2.5 bar values... but I was pretty sure they were not the same.

Hybrid96EK · Post by **Hybrid96EK** » Mon Mar 02, 2009 11:27 pm

I think I found it.. The max is 3000mbar, the min is listed as the same as the 4 bar, so 34.7. I will try it out later on tonight and report back!

Hybrid96EK · Post by **Hybrid96EK** » Tue Mar 03, 2009 1:18 am

well that cant be it. With 34 or 35 in the 0v section the car won't even idle. fires up, revs a touch, the leans out horribly and dies. I can rev it, but even then it will eventually lean out and croak.. I'll keep looking I guess.

Hybrid96EK · Post by **Hybrid96EK** » Tue Mar 03, 2009 10:55 am

Alright, I got it. The Xenocron 3 bar settings worked fine... I just forgot to adjust the scalar on the new map to match my old one!