close loop configuration

red_zone · Post by **red_zone** » Tue Mar 17, 2009 9:03 am

hello,i have a lc1 wb,I have set the output 1 as narrowband, and connected to the input d14.the output 2 is configured as wideband, and connected to the input d12,to datalog. in closeloop menu, there is a tick to select as the wideband closeloop, I choose this option? what is the correct configuration for my setupÂ¿? thanks

red_zone · Post by **red_zone** » Tue Mar 17, 2009 2:35 pm

nobody wiht my wiring settingsÂ¿?

Post by **Bugermass** » Tue Mar 17, 2009 4:30 pm

if you choose wideband as closed loop, closed loop will run off the wideband input, if your going to run it this way theres no reason to wirein the narrow band wire.. In my opnion closed loop using wideband is better so I'd do it this way..

red_zone · Post by **red_zone** » Wed Mar 18, 2009 10:25 am

I then disconnect the input d14 and only work with d12, where I have the wideband connected is not so?

red_zone · Post by **red_zone** » Thu Mar 26, 2009 8:17 am

can me explain,what is the ve corrections tables?